TY - JOUR
T1 - Electrochemical oxidation of reverse osmosis concentrate on boron-doped diamond anodes at circumneutral and acidic pH
AU - Bagastyo, Arseto Y.
AU - Batstone, Damien J.
AU - Kristiana, Ina
AU - Gernjak, Wolfgang
AU - Joll, Cynthia
AU - Radjenovic, Jelena
N1 - Funding Information:
This study was supported by the Australian Research Council ( LP0989159 and LP100100285 ), Veolia Water Australia , Seqwater, Queensland Health Forensic and Scientific Service and the South East Queensland Urban Water Security Research Alliance . The authors would like to acknowledge Jace Tan for her assistance in performing halogen-specific AOX analyses. Arseto Bagastyo is currently also a staff member on leave at Institut Teknologi Sepuluh Nopember, Indonesia.
PY - 2012/11/15
Y1 - 2012/11/15
N2 - Electrochemical processes have been widely investigated for degrading organic contaminants present in wastewater. This study evaluated the performance of electrochemical oxidation using boron-doped diamond (BDD) electrodes by forming OH for the treatment of reverse osmosis concentrate (ROC) from secondary-treated wastewater effluents. Since oxidation by OH and active chlorine species (HClO/ClO-) is influenced by pH, the electrochemical oxidation of ROC was evaluated at controlled pH 6-7 and at pH 1-2 (no pH adjustment). A high concentration of chloride ions in the ROC enhanced the oxidation, and 7-11% of Coulombic efficiency for chemical oxygen demand (COD) removal was achieved with 5.2 Ah L-1 of specific electrical charge. Complete COD removal was observed after 5.2 and 6.6 Ah L-1, yet the corresponding dissolved organic carbon (DOC) removal was only 48% (at acidic pH) and 59% (at circumneutral pH). Although a higher operating pH seemed to enhance the participation of OH in oxidation mechanisms, high concentrations of chloride resulted in the formation of significant concentrations of adsorbable organic chlorine (AOCl) after electrochemical oxidation at both pH. While adsorbable organic bromine (AOBr) was degraded at a higher applied electrical charge, a continuous increase in AOCl concentration (up to 0.88 mM) was observed until the end of the experiments (i.e. 10.9 Ah L-1). In addition, total trihalomethanes (tTHMs) and total haloacetic acids (tHAAs) were further degraded with an increase in electrical charge under both pH conditions, to final total concentrations of 1 and 4 μM (tTHMs), and 12 and 22 μM (tHAAs), at acidic and circumneutral pH, respectively. In particular, tHAAs were still an order of magnitude above their initial concentration in ROC after further electrooxidation. Where high chloride concentrations are present, it was found to be necessary to separate chloride from ROC prior to electrochemical oxidation in order to avoid the formation of chlorinated by-products.
AB - Electrochemical processes have been widely investigated for degrading organic contaminants present in wastewater. This study evaluated the performance of electrochemical oxidation using boron-doped diamond (BDD) electrodes by forming OH for the treatment of reverse osmosis concentrate (ROC) from secondary-treated wastewater effluents. Since oxidation by OH and active chlorine species (HClO/ClO-) is influenced by pH, the electrochemical oxidation of ROC was evaluated at controlled pH 6-7 and at pH 1-2 (no pH adjustment). A high concentration of chloride ions in the ROC enhanced the oxidation, and 7-11% of Coulombic efficiency for chemical oxygen demand (COD) removal was achieved with 5.2 Ah L-1 of specific electrical charge. Complete COD removal was observed after 5.2 and 6.6 Ah L-1, yet the corresponding dissolved organic carbon (DOC) removal was only 48% (at acidic pH) and 59% (at circumneutral pH). Although a higher operating pH seemed to enhance the participation of OH in oxidation mechanisms, high concentrations of chloride resulted in the formation of significant concentrations of adsorbable organic chlorine (AOCl) after electrochemical oxidation at both pH. While adsorbable organic bromine (AOBr) was degraded at a higher applied electrical charge, a continuous increase in AOCl concentration (up to 0.88 mM) was observed until the end of the experiments (i.e. 10.9 Ah L-1). In addition, total trihalomethanes (tTHMs) and total haloacetic acids (tHAAs) were further degraded with an increase in electrical charge under both pH conditions, to final total concentrations of 1 and 4 μM (tTHMs), and 12 and 22 μM (tHAAs), at acidic and circumneutral pH, respectively. In particular, tHAAs were still an order of magnitude above their initial concentration in ROC after further electrooxidation. Where high chloride concentrations are present, it was found to be necessary to separate chloride from ROC prior to electrochemical oxidation in order to avoid the formation of chlorinated by-products.
KW - Adsorbable organic halogen
KW - Boron-doped diamond anode
KW - Electrochemical oxidation
KW - Reverse osmosis concentrate
UR - http://www.scopus.com/inward/record.url?scp=84867139743&partnerID=8YFLogxK
U2 - 10.1016/j.watres.2012.08.038
DO - 10.1016/j.watres.2012.08.038
M3 - Article
C2 - 22995242
AN - SCOPUS:84867139743
SN - 0043-1354
VL - 46
SP - 6104
EP - 6112
JO - Water Research
JF - Water Research
IS - 18
ER -