Abstract
Reinforced concrete half-joints are susceptible to deterioration mechanisms primarily due to the leakage of surface water, often contaminated with chlorides from de-icing salts, through the expansion joint. Due to the joint geometric form, favourable conditions can be created inside the joint for the corrosion of steel reinforcement. To this end, seven reinforced concrete half-joints were tested to failure under three-point bending to investigate the effect of reinforcement reductions that simulate common deterioration scenarios arising from the corrosion of reinforcement. The results were then compared to the predictions of nonlinear finite element analyses and the strut-and-tie method. The results demonstrated that a reduction in the amount of reinforcement close to the re-entrant corner has major influence on the load-deflection response of reinforced concrete half-joints. The largest reductions in load-carrying capacity were obtained from the half-joints with a full removal of diagonal bars and a combined removal of diagonal and U-bars, both showing reductions in load capacity of more than 50 %. The failure mode in each case of simulated deterioration scenarios involved a shear failure at the nib, except one case which displayed a shear failure in the full depth section due to the reduced anchorage of the bottom reinforcement. Furthermore, it was shown that nonlinear finite element analyses provide accurate predictions of the load-deflection response and failure crack patterns. The strut-and-tie method was found to result in overly conservative predictions, with an average observed-to-predicted load ratio of 1.48 and a coefficient of variation (COV) of 10.2 %. This is considerably higher than an average load ratio of 1.05 and a COV of only 3.1 % obtained from the nonlinear finite element analyses.
Original language | English |
---|---|
Article number | 118934 |
Journal | Engineering Structures |
Volume | 321 |
DOIs | |
Publication status | Published - 15 Dec 2024 |
Keywords
- Crack pattern
- Deterioration
- Half-joint
- Nonlinear finite element
- Reinforcement
- Strut-and-tie